until the blinking stops or the LED changes color (usually to green or solid red).

A text file detailing the specific jumper settings or installation steps for that firmware version.

Flashing the wrong resolution or version (e.g., using a 1920x1080 file for a 1920x1200 screen) can lead to a distorted display or a "bricked" board. Always verify the and Voltage (3.3V, 5V, or 12V) via jumpers before applying power.

Reconnect power. The status LED will usually blink rapidly, indicating the update is in progress.

The file typically contains the firmware required to program or update an LCD/LED TV control board—specifically models associated with the or similar universal controller boards.

Place the extracted .bin file directly in the root directory of the USB drive (not inside any folders). Flash the Board: Disconnect power from the controller board. Insert the USB drive into the board's USB port.

Sometimes included to customize the boot screen or on-screen display (OSD) menus. How to Use This Download

Remove the USB drive and cycle the power to finish the setup. Safety Warning