THE LARGEST BMW 2-SERIES FORUM ON THE PLANET
: This is usually the first piece installed. Cut it to the width of the opening using a hacksaw. Secure it to the top jamb or ceiling header using screws, ensuring it is perfectly level. Lower Track :
Lift the (the one further inside the closet) first.
: If your kit includes stoppers or soft-close mechanisms, slide them into the top track and tighten them at the points where the doors should stop. Recommended Tools Level and tape measure Drill with pilot bits Hacksaw (to trim tracks) Screwdriver (for adjustment screws) Installing a Sliding Closet Door Track instruktsiia po ustanovki dveri kupe
Installing sliding "coupe" doors (whether for a wardrobe or as an interior room divider) is a manageable DIY project that focuses on precise measurements and level tracks. 1. Preparatory Measurements Before installation, verify your opening dimensions.
: If the door doesn't sit flush against the wall, locate the adjustment screws on the bottom rollers. : This is usually the first piece installed
: Screw the roller brackets to the top (and sometimes bottom) of the door panels, usually 1–1.5 inches from the side edges. Mount the Panels :
Angle the top into the rear groove of the upper track, then lower the bottom rollers into the rear groove of the bottom track. Repeat the process for the . 4. Final Adjustments Lower Track : Lift the (the one further
: Typically, the combined door panels should be at least 10 cm wider than the opening to provide a sufficient overlap when closed. 2. Installing the Tracks
