Plug your turntable's RCA leads into the or MM inputs on the back of the PP 2, depending on your cartridge type. Match the colors: Red for Right (R) and White for Left (L).
: Never connect the PP 2 to an input marked "PHONO" on your receiver, as this will cause severe distortion. Nad Phono Preamp Pp2 Manual
Ensure the turntable's ground wire is securely attached to the PP 2 . Plug your turntable's RCA leads into the or
: Ensure all equipment is turned off and the PP 2 is disconnected from its power supply. Connect Turntable : Ensure the turntable's ground wire is securely attached
The is a compact, low-noise device designed to add a turntable to modern amplifiers or receivers that only have "Line-Level" inputs (like CD, AUX, or Tuner). It supports both Moving Magnet (MM) and Moving Coil (MC) cartridges via separate inputs and a rear selector switch. 1. Setup & Installation
Check if the . If not, verify the power supply connections. Ensure the correct input is selected on your amplifier. Hum or Buzz :