X1 -

Select on the screen; the nozzle will heat up and pull the filament through. Your First Print

: Clean the plate with dish soap and water to remove oils, then apply a thin layer of glue stick if using the Cool Plate or Engineering Plate for better adhesion. Load Filament : Place your filament spool on the holder or in the AMS. Select on the screen; the nozzle will heat

: Connect the ribbon cable and slide the screen into its front slot. : Connect the ribbon cable and slide the

: Use the plastic bag handles to lift the printer out of the box. Remove Internal Restraints : To prepare your for its first print, you

Once the hardware is clear, the printer needs to "learn" its own geometry and load material.

To prepare your for its first print, you must first clear all internal shipping restraints and perform an initial calibration. The process typically involves unboxing, removing protective foam, and setting up the software interface. Initial Physical Setup

: Mount the spool holder to the back of the unit using the provided screws. Calibration & Loading Filament